Manual

(CONTINUED)
Then take a 1/8” hex key and replace and tighten
down the valve plug screw
(SEE FIGURE 25L).
Using Eclipse Gun Oil or Eclipse Grease lubricate the
LPR body o-rings
(SEE FIGURE 25M).
Take the exhaust valve and insert the white end into
the valve spring, and the other end of the valve spring
into the back of the LPR body (creating a stack of
parts)
(SEE FIGURE 25N).
Take the stack and insert it into the valve chamber
bore of the Etek4 body, exhaust valve first
(SEE
FIGURE 25O).
When inserted, line up the holes in the LPR body with
the FRM screw hole in the Etek4 body
(SEE FIGURE
25P).
Insert and tighten down the FRM screw using a 1/8”
hex key
(SEE FIGURE 25Q).
Attach the Etek4 frame (See page 65).
You have now stripped and cleaned your Etek4
Exhaust Valve Assembly.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
WARNING
FIG 25mFIG 25L
FIG 25N
FIG 25P
FIG 25O
FIG 25Q
72.
mAINTENANCE