Manual

(CONTINUED)
Clean and check the condition of the single internal
005 NBR 90 o-ring in the front of the OOPS insert and
replace if neces
sary (SEE FIGURE 26G). Lubricate
this o-ring liberally using Eclipse Grease.
Lubricate the n
arrow end of the OOPS pin with a
smear of Eclipse Grease and push the OOPS pin,
narrow end first, into the OOPS insert so that it sits in
the OOPS insert and pokes through t
o the front (SEE
FIGURES 26H & 26I)
.
Screw
the OOPS insert back into the OOPS body
ensuring that the o-ring end goes in f
irst.
Replac
e the push rod into its designated sl ot (SEE
FIGURE 26j)
then side 004 NBR 70 o-rings onto
both ends of the push rod. Make sure the push rod is
centred in the OOPS body
(SEE FIGURE 26K).
Sli de the OOPS knob over the OOPS body and screw
the knob onto the body
(SEE FIGURE 26L) .
Rec
onnect the macroline hose to the fitting on the
OOPS body
(SEE FIGURE 26M).
You h
ave now successfully cleaned and maintained
your On/Off Purge System
.
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
WARNING
FIG 25O
FIG 26G
FIG 26I
FIG 26K
FIG 26H
FIG 26J
FIG 26L
FIG 26m
74.
mAINTENANCE