Manual

USING THE BREAK BEAM
SENSOR SYSTEM
When the Etek4 is powered up, the Break Beam
Sensor System (BBSS) is automatically enabled.
To switch off the Break Beam Sensor System, push
and hold the Select button
for 0.5 seconds. The ‘E’
on the navigation console will flash purple indicating
that the Break Beam Sensor System has been
disabled.
To switch on the Break Beam Sensor System, push
and hold the Select button
for 0.5 seconds. The ‘E’
on the navigation console will flash either yellow (no
ball detected) or light blue (ball detected) indicating
that the Break Beam Sensor System has been
enabled.
Additional features of the Etek4 Break Beam Sensor
System are covered in full in the ‘Understanding the
BBSS Operation’ section on page 30 of this User
Manual.
PURPLE LIGHT -
BBSS DISABLED
YELLOW LIGHT - NO
BALL DETECTED
LIGHT BLUE LIGHT
- BALL DETECTED
8.
QUICK SET-UP