Manual

ADVANCED SET-UP
28 ETEK5 MANUAL
DWELL
The Dwell parameter controls the amount of time that the
solenoid valve is energised and therefore the amount of gas
that is released with each shot.
The Dwell parameter is indicated by a purple light on the
navigation console when you are in the set-up mode.
This parameter is adjustable between 8.0ms and 16.0ms in
0.1ms increments.
DEBOUNCE
The Debounce parameter is used to set the level of
Debounce (anti-trigger bounce) on the ETEK5.
The Debounce parameter is indicated by a light blue LED on
the navigation console when you are in the set-up mode.
This parameter is adjustable between 1 and 10 with a higher
value reducing the amount of trigger bounce.
THE FACTORY RESET
Whilst in set-up mode, it is possible to reset all of the control
parameters to the factory default settings in the following
way:
1 Push and hold the tournament lock button (see page
24 for information on the tournament lock button) for two
seconds.
2 The LED on the navigation console will repeatedly ash
blue to indicate that the factory default settings have
been restored.
The ETEK5 software parameters and presets are correct at time of printing. However newer
versionsoftheETEK5softwaremayhavedierentparametersandpresetstothoseprintedabove.
Some parameters may have ben added or removed entirely. Please contact your nearest service
centre if you have any queries regarding the ETEK5 software installed in your marker.