Manual

ETEK5 OLED BOARD
32 ETEK5 MANUAL
THE BREECH SENSOR INDICATOR
The BS is able to switch itself off in the event of a blockage or contamination
preventing it from functioning correctly. In this instance, the BS will switch itself
back on once the blockage is cleared and the correct operation can be resumed.
The BS indicator on the main screen is used to indicate the four possible states
of the BS as follows:
THE LOCK INDICATOR
The ETEK5 has a tournament lock which prevents the user from making changes
to any parameter that affects the way in which the ETEK5 shoots.
When the lock is enabled the lock indicator will show a closed padlock
.
When the lock is disabled the lock indicator will show an open padlock
.
To enable or disable the tournament lock see (see page 24).
THE BATTERY LEVEL INDICATOR
When the battery is fresh the indicator will show a ‘full’ battery . As the battery
drains the indicator will reect this and when the battery needs to be replaced the
indicator will start to ash.
At this point the battery must be changed immediately.
The indicator will also show if there is a problem with the battery monitoring circuit.
BS Enabled and ball detected
The ETEK5 can be red at the maximum rate of re
determined by the chosen ring mode.
BS Enabled no ball detected
The ETEK5 cannot be red.
BS Disabled
The ETEK5 can be red at a maximum rate of re as set by the BS
OFF ROF parameter (see page 34).
BS Fault detected
The system is disabled. The ETEK5 can only be red at a maximum
rate of 2 bps less than the maximum rate of re, up to a maximum of
10 bps.
Locked
Set-up mode cannot be accessed and therefore no parameters can
be changed. This is the tournament legal state.
Unlocked
Set-up mode can be accessed.
Full battery
The battery is fully charged.
Drained battery
Battery is at approximately 30% of useful charge.
Battery circuit fault
The battery level cannot be determined.