Manual

ETEK5 MANUAL 51
THE ETEK5 SOLENOID ASSEMBLY
With the frame separated from the ETEK5 body (see gure 29A) and the solenoid
assembly and BS assembly unplugged from the circuit board (see page 47), use
a small Phillips head screw driver to undo and remove the two M1.6x16 screws
that hold the solenoid assembly onto the solenoid manifold (see gure 29B).
Removing the solenoid will completely reveal the solenoid manifold
(see gure 29C), using a 5/64 hex key remove all three M2.5x5 screws which
hold the manifold to the ETEK5 body (see gure 29D).
With the solenoid assembly completely removed from the ETEK5 body the bottom
of the ETEK5 body should now resemble gure 29E. Ensure that the air transfer
holes in the bottom of the body are free from contamination from any dirt, debris,
paint or moisture and clear away any excess grease if it appears to be blocking
any of the transfer holes.
Check the top and bottom of the solenoid manifold to ensure that it is also free
from damage or debris (see gure 29E). Remove and clean the rubber gaskets
as shown in gure 29F. Replace the rubber gaskets ensuring that they lie at in
their designated grooves in the solenoid manifold body. Lubricate the gaskets
with a small amount of Eclipse Grease.
Re-attach the solenoid manifold to the ETEK5 body with the three M2.5x5 screws.
MAINTENANCE
WARNING!
Always de-gas your marker, discharging any stored gas in a safe direction,
and remove the barrel, loader, air system and any paintballs to make the
marker easier and safer to work on.
If you are unsure about performing a maintenance procedure please
contact your nearest service centre.
WARNING
FIG 29A
FIG 29C
FIG 29E
FIG 29G
FIG 29B
FIG 29D
FIG 29F