Manual

the ShAft4 bArreL
A
B
D
C
The Eclipse Etha comes as standard with an Eclipse Shaft4 barrel .
1,4
The barrel screws into the front of the Etha using a right hand thread meaning
that if you hold the Etha pointing away from you the
barrel screws into the body in a
counter-clockwise direction.
2
The barrel comprises of two parts, a barrel back
A
and a barrel tip
B
. The two
parts are joined together with a
left hand thread meaning that if you hold the barrel ,
with the back section nearest you, the
barrel tip screws in a clockwise direction.
On the barrel back there is a 016 NBR 70 o-ring
C
which prevents the Shaft4 barrel
from vibrating loose from the
Etha body when the marker is fired. There is also a 016
NBR 70 o-ring on the front of the
barrel back
D
helps with alignment when the two
barrel sections are screwed together.
Replace and lubricate these o-rings with Eclipse Grease as necessary.
1
The bore size of your Shaft4 may vary according to the
model of Etha that you have.
2
The Etha will only accept COCKER threaded barrels.
Do not use any other type of barrel thread.
3
The Eclipse Shaft4 tip and back barrel sections are
not interchangeable with older version Shaft tip and
back barrel sections (including Shaft3 barrel kits).
4
The model of barrel accompanying your Etha may
differ from that stated in this manual.
ORIENTATION
INTRODUCTION
USING THE ETHA
USER INTERFACE
MAINTENANCE
FAULT FINDING
PARTS LIST
SERVICE CENTRES
INDEX
QUICK SET-UP
CONTENTS
13
ORIENTATION
QUICK GUIDE