Manual

SettinG up the ethA
Before you can begin to use your Etha, you will need to
attach a barrel, an air system and a paintball loader.
inStALLinG A bArreL
Every Etha comes complete with an Eclipse Shaft4
barrel (see page 13).
To install the Shaft4 barrel, firstly screw the barrel tip
and barrel back sections together. The threads on the
Shaft4 barrel tip are
reverse threaded , to screw the two
sections together, with the barrel pointing away from
you, turn the barrel tip in a clockwise direction
(See
fiGure 6A)
.
While pointing the Etha marker in a safe direction,
insert the assembled Shaft4 barrel into the front of
the Etha body and screw the Shaft4 barrel into the Etha
(in a counter-clockwise direction). Continue to screw
the Shaft4 barrel into the Etha body until the barrel
becomes tight in the body. DO NOT over tighten the
barrel
(See fiGure 6b).
Install a barrel blocking device over the barrel such as
the Eclipse barrel sock supplied with the Etha
1
(See
fiGure 6c)
. You have now installed the barrel.
t-SLot MountinG SYSteM
The Etha utilises a T-slot arrangement to mount the
OOPS to the bottom of the frame
A
. There are two
retaining screws on the OOPS body underside
B
.
These are used to clamp the OOPS onto the frame. It
is advisable to make sure that these screws are tight
using a 3/8” hex key before attaching an air system
(See fiGure 6d).
1
Instruction on using the Eclipse barrel sock can be found on the
barrel sock warning label.
A
B
MAKE SURE THE MARKER IS TURNED OFF AND
THAT NO PAINTBALLS ARE IN THE MARKER OR
LOADER BEFORE INSTALLING A BARREL.
FIG 6A
FIG 6b FIG 6C
FIG 6d
uSING THE ETHA
20