Manual

90 deGree MAcroLine
fittinG
A 90 degree macroline fitting can be found on the
SL3 inline regulator as shown in
fiGure 7A. This
fitting is secured into the inline regulator using
thread
lock
and DOES NOT need to be removed for regular
maintenance of the SL3 inline regulator.
StrAiGht MAcroLine
fittinGS
A Straight macroline fitting can be found on the OOPS
as shown in
fiGure 7b. This fitting is secured to
the OOPS using
thread lock and DOES NOT need to be
removed for regular maintenance of the OOPS.
MAcroLine hoSinG
To aid the longevity of your macroline hosing, it is
very important to remove it from and install it back
into the fittings in the correct manner:
Pull back the collet section of the hose fitting and
keep the collet depressed. Pull the macroline hose out
of the hose fitting and release the collet.
Before installing the macroline hose into the fitting
ensure that the end has been trimmed correctly and
is the correct length to ensure a tight fit in the hose
fitting.
IF THE MACROLINE BECOMES WORN, DAMAGED
OR IS THE WRONG LENGTH, REPLACE IT
IMMEDIATELY.
REPLACE THE MACROLINE HOSE WITH THE
FOLLOWING GRADE OR HIGHER -
1/4” OD X 1/8”ID SEMI RIGID NYLON 11
IF UNSURE CONTACT YOUR NEAREST ECLIPSE
SERVICE CENTRE
FIG 7A
FIG 7b
ORIENTATION
INTRODUCTION
USING THE ETHA
USER INTERFACE
MAINTENANCE
FAULT FINDING
PARTS LIST
SERVICE CENTRES
INDEX
QUICK SET-UP
CONTENTS
21
USING THE ETHA
QUICK GUIDE