Manual

(continued)
High, mid and low pressure output preset air systems
can be used with the Etha, providing the Etha is fitted
with the SL3 inline regulator originally supplied with
the marker.
The Eclipse Etha comes complete with an Eclipse
On/Off Purge System (OOPS) which provides a direct
connection for a preset air system. Before screwing
an air system into the OOPS ensure that the OOPS
knob is fully unscrewed
(See fiGure 8A). In this
position the OOPS is off and will not pressurise the
Etha when an air system is screwed into the OOPS.
Lining the threads up correctly between the OOPS and
the air system, screw the air system into the OOPS
until the air system is screwed all the way in and tight
on the OOPS. The air system MUST be screwed all the
way in before turning on the OOPS
(See fiGure
8b)
.
Now with the air system attached and the barrel
pointing away from you, start to slowly turn the OOPS
knob counter-clockwise to turn the ‘OOPS’ on and
pressurise the Etha. Keep turning the knob until it
stops against the OOPS body as shown in
fiGure
8c
.
You have now installed a preset air system onto your
Etha.
FIG 8A
FIG 8b
FIG 8C
ORIENTATION
INTRODUCTION
USING THE ETHA
USER INTERFACE
MAINTENANCE
FAULT FINDING
PARTS LIST
SERVICE CENTRES
INDEX
QUICK SET-UP
CONTENTS
23
USING THE ETHA
QUICK GUIDE