Manual

unLoAdinG the ethA
Securely attach a barrel blocking device such as the
Eclipse barrel sock
1
(supplied with the Etha) to the
marker as shown in
fiGure 12A.
Turn off the Etha electronics by holding down the
button on the back of the frame. When the LED
display turns red then extinguishes, the marker has
been turned off
(See fiGure 12b).
With the Etha pointing away from you. De-gas the
marker by turning OOPS knob clockwise until the
OOPS begins to vent air. Only when the OOPS has fully
degassed the Etha marker, unscrew the air system
from the OOPS
(See fiGure 12c).
Open the clamping lever on the feed neck and slacken
off the top feed screw if necessary on the feed neck.
Carefully pull the loader out of the feed neck
(See
fiGure 12d)
.
Looking down the feed neck, check to see if there are
any paintballs still in the breech, if there are, turn
the marker upside down while still keeping the barrel
facing away from any persons within firing range
then tip out any paintballs within the breech
(See
fiGure 12e)
.
-Next remove the barrel blocking device, and unscrew
the barrel
(See fiGure 12f). Remove any
paintballs within the barrel.
The Eclipse Etha has now been unloaded and is ready
for storage.
1
Instruction on using the Eclipse barrel sock can be found on the
sock warning label.
ALWAYS KEEP THE ECLIPSE ETHA POINTED IN
A SAFE DIRECTION AND ENSURE ALL PERSONS
WITHIN RANGE CONTINUE TO WEAR FACE
PROTECTION, UNTIL MARKER IS COMPLETELY
UNLOADED AND SAFE.
F IG 12 A
F IG 12 C
F IG 12E
F IG 12b
F IG 12d
F IG 12F
ORIENTATION
INTRODUCTION
USING THE ETHA
USER INTERFACE
MAINTENANCE
FAULT FINDING
PARTS LIST
SERVICE CENTRES
INDEX
QUICK SET-UP
CONTENTS
27
USING THE ETHA
QUICK GUIDE