Manual

the tournAMent Lock
The Etha has an electronic tournament lock which,
once enabled, prevents the user from making any
changes to the setup parameters of the marker. This
tournament lock complies with the rules of all major
tournaments and must be enabled prior to entering
the field of play in order to avoid penalties.
The Etha is shipped from the factory with the
Tournament Lock disabled.
To enable the Tournament lock;
1. Remove the right side grip panel by unscrewing the
retaining screw using a 5/64” hex key
(See fiGure
13A)
.
2. Turn on the Etha.
3. Locate and press the tournament lock button on the
circuit board
(See
A
fiGure 13b). The navigation
console will flash green to indicate that the tournament
lock has been enabled.
4. Replace the right side grip panel then the
retaining screw using a 5/64” hex key.
To disable the tournament lock;
1. Remove the right side grip panel by unscrewing the
retaining screw using a 5/64” hex key
(See fiGure
13A)
.
2. Turn on the Etha.
3. Locate and press the tournament lock button on
the circuit board
(See
A
in fiGure 13b).
The navigation console will flash red to indicate that
the tournament lock has been disabled.
4. Replace the right side grip panel then the
retaining screw using a 5/64” hex key.
ALWAYS KEEP THE ECLIPSE ETHA POINTED IN
A SAFE DIRECTION AND ENSURE ALL PERSONS
WITHIN RANGE CONTINUE TO WEAR FACE
PROTECTION, UNTIL MARKER IS COMPLETELY
UNLOADED AND SAFE.
A
F IG 13 A
F IG 13b
ORIENTATION
INTRODUCTION
USING THE ETHA
USER INTERFACE
MAINTENANCE
FAULT FINDING
PARTS LIST
SERVICE CENTRES
INDEX
QUICK SET-UP
CONTENTS
29
USING THE ETHA
QUICK GUIDE