Manual

the Set up Mode
The set up mode can only be entered if the tournament
lock is off. See page 29 for details on the tournament
lock.
To activate the set up mode, firstly ensure that the
Etha is switched off. Pull and hold the trigger down,
and whilst the trigger is still pulled, push and hold the
button until the LED on the navigation console
flashes white to indicate entry into the set up mode.
Release the trigger and the
button, the LED on
the navigation console will turn red to indicate the first
set up parameter.
Press the
button to scroll through each of the set
up parameters:
To see the value of the selected parameter, pull and
quickly release the trigger. The value will be indicated
in units (long flashes) and then tenths (short flashes)
on the LED display in the colour of the selected
parameter.
E.g. A Dwell of 14.5ms would be indicated as follows-
- 14 LONG FLASHES OF A PURPLE LED
- 5 SHORT FLASHES OF A PURPLE LED
A zero is indicated by no flashes. E.g. A Dwell of
11.0ms would be indicated as follows:
- 11 LONG FLASHES OF A PURPLE LED
- 0 SHORT FLASHES OF A PURPLE LED
ModifYinG A pArAMeter
You can modify a parameter by using the following
guidelines.
1. Ensure that you are in set up mode.
2. Choose the parameter that you wish to modify by
pressing
until the LED turns to the parameter
colour.
3. Pull and hold the trigger for 1 second. The LED will
go off.
4. Set the units value by pulling the trigger once for
each unit, the LED will flash with each trigger pull.
5. Push the button to switch to the tenths value
1
.
6. Set the tenths value by pulling the trigger once for
each unit, the LED will flash with each trigger pull. DO
NOT pull the trigger if the required digit is zero
1
.
7. Push the button. The LED will flash three
times; if the colour is green then the value has been
accepted and saved. If the colour is red then the value
has been rejected and remains unchanged.
For example to set a parameter to 14.5 when following
the steps above -
- PULL THE TRIGGER 14 TIMES WHEN AT STEP 4
THEN PRESS
- PULL THE TRIGGER 5 TIMES WHEN AT STEP 6
THEN PRESS
To leave a parameter unchanged having already
started to modify it, do not pull the trigger for 5
seconds and the value will be rejected.
eXitinG Set up Mode
To exit set up mode, push and hold the button
until the LED turns blue. Then release the
button,
the Etha will exit set up mode and the LED will start
flashing, displaying the current BBSS status.
1
If the parameter does not support tenths then these steps are
skipped.
COLOUR
PARAMETER
RANGE
Red
Green
Blue
Purple
Light Blue
Firing Mode
Maximum ROF
with BBSS on
(capped modes
only).
Dwell
Debounce
1 to 4
4.0 bps to 15.0
bps
4.0 bps to 15.0
bps
4.0 ms to 15.0 ms
1 to 10
Maximum ROF
with BBSS off.
ORIENTATION
INTRODUCTION
USING THE ETHA
USER INTERFACE
MAINTENANCE
FAULT FINDING
PARTS LIST
SERVICE CENTRES
INDEX
QUICK SET-UP
CONTENTS
31
USER INTERFACE
QUICK GUIDE