Manual

Set up pArAMeterS
The first three set up parameters will need to be set
to comply with the rules of the field or site at which
this Etha is used. It is the user’s responsibility to
ensure that these parameters are correctly set.
the firinG Mode
pArAMeter
This parameter is used to control
the firing mode of the Etha. The
firing mode parameter is indicated
by a red light on the navigation
console when you are in the set up
mode. There are four selectable
firing modes as outlined below:
1 : UNCAPPED SEMI
In this mode the Etha will fire one
shot for every pull of the trigger.
This mode is uncapped with the
BBSS enabled. If the BBSS is off
then the rate of fire is limited by
the Maximum ROF with BBSS Off
parameter.
2 : CAPPED SEMI
This mode is the same as the Uncapped Semi mode,
except that the rate of fire (ROF) is determined by the
maximum ROF parameters (BBSS On and BBSS Off).
3 : PSP 2011 COMPLIANT RAMPING
This mode allows the marker to fire in a ramping
mode as specified in the 2011 PSP Series rules.
4 :
MILLENNIUM 2010 COMPLIANT RAMPING
This mode allows the marker to fire in a ramping
mode as specified by the 2010 Millennium Series
rules.
Certain modes may only be available in certain
countries and on certain models of the Etha.
the MAXiMuM rof
With bbSS on
(cApped ModeS)
In capped firing modes this
parameter is used to control how
fast the Etha can cycle.
The Maximum ROF with BBSS On
parameter is indicated by a green
light on the navigation console when
you are in the set up mode.
This is fully adjustable between 4.0
balls per second and 15.0 balls per
second in 0.1 bps increments.
the MAXiMuM rof With
bbSS off
This parameter is used to control
how fast the Etha cycles when the
Break Beam Sensor System has been
disabled.
The Maximum ROF with BBSS Off
parameter is indicated by a blue
light on the navigation console when
you are in the set up mode.
This parameter is fully adjustable
between 4.0 balls per second and
15.0 balls per second in 0.1 bps
increments.
This parameter should be set to
match the slowest speed of the
loading system in use.
The Etha software parameters and presets are correct at time of printing. However newer versions of the Etha software may have different
parameters and presets to those printed above. Some parameters may have ben added or removed entirely. Please contact your nearest
service centre if you have any queries regarding the Etha software installed in your marker.
uSER INTERFACE
32