Manual

the triGGer ASSeMbLY
To remove the trigger from the Etha, firstly unscrew
the two retaining screws that hold the left and right
grip panels onto the frame using a 5/64” hex key
(See
fiGure 21A)
, then remove the grip panels.
With a 1/16” hex key, loosen the trigger pin retaining
screw
(See fiGure 21b). As the screw is backed
out the trigger pin will become free. When the trigger
pin moves freely inside the frame use a small hex
key to push the trigger pin out of the frame
(See
fiGure 21c)
.
With the trigger pin removed, carefully rotate the
trigger forwards, and slide it out of the frame
(See
fiGure 21d)
, making sure not to damage to micro-
switch.
The trigger has now been removed for cleaning.
DE-GAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE
THE BARREL, LOADER, AIR SYSTEM AND ANY
PAINTBALLS TO MAKE THE MARKER EASIER AND
SAFER TO WORK ON.
FIG 21A
F IG 21b
F IG 21C
F IG 21d
MAINTENANCE
46