Manual

(continued)
Clean and check the condition of the single internal
005 NBR90 o-ring in the front of the OOPS insert and
replace if necessary
(See fiGure 24G). Lubricate
this o-ring liberally using Eclipse Grease.
Lubricate the narrow end of the
OOPS pin with a smear
of Eclipse Grease and push the
OOPS pin , narrow end
first, into the
OOPS insert so that it sits in the OOPS
insert and pokes through to the front (See fiGureS
24h & 24i)
.
Screw the
OOPS insert back into the OOPS body
ensuring that the o-ring end goes in first.
Replace the
push rod into its designated slot (See
fiGure 24j)
then side 004 NBR70 o-rings onto both
ends of the
push rod . Make sure the push rod is centred
in the
OOPS body (See fiGure 24k).
Slide the OOPS knob over the OOPS body and screw the
knob onto the body (See fiGure 24L).
Reconnect the
macroline hose to the fitting on the OOPS
body (See fiGure 24M).
You have now successfully cleaned and maintained your
On/Off Purge System .
IF YOU ARE AT ALL UNSURE OF PERFORMING A
MAINTENANCE PROCEDURE PLEASE CONTACT
YOUR NEAREST SERVICE CENTRE.
FIG 25O
FIG 24G
FIG 24I
FIG 24K
FIG 24H
FIG 24J
FIG 24l
FIG 24M
MAINTENANCE
52