Manual

uSinG the breAk beAM
SenSor SYSteM
The Break Beam Sensor System, referred to elsewhere
in this manual as ‘BBSS’ is used to detect when a
paintball is ready to be fired from the Etha. If no
paintball is ready then the BBSS will inhibit the Etha
from firing. This prevents the Etha from “chopping”
paintballs that are not fully loaded into the marker.
When the Etha is powered up, the BBSS is
automatically enabled. The current state of the BBSS
is displayed by a flashing LED on the navigation
console.
To switch OFF the Break Beam Sensor System, push and
hold the select button
for 0.5 seconds. The LED on
the navigation console will flash purple indicating that
the Break Beam Sensor System has been disabled.
To switch ON the Break Beam Sensor System, push and
hold the select button
for 0.5 seconds. The LED on
the navigation console will flash either yellow (no ball
detected) or light blue (ball detected) indicating that
the Break Beam Sensor System has been enabled.
Additional features of the Etha Break Beam Sensor
System are covered in the ‘Understanding the BBSS
Operation’ section on Page 30 of this User Manual.
purpLe LiGht -
bbSS diSAbLed
YeLLoW LiGht -
no bALL detected
LiGht bLue LiGht -
bALL detected
ORIENTATION
INTRODUCTION
USING THE ETHA
USER INTERFACE
MAINTENANCE
FAULT FINDING
PARTS LIST
SERVICE CENTRES
INDEX
QUICK SET-UP
CONTENTS
9
QUICK SET-UP
QUICK GUIDE