Manual

FIG-1
HEX
1/16
11
ETHA2
C
QUICK START
TRIGGER ADJUSTMENT
FIG-1
The pre-travel screw
A
adjusts the distance the trigger travels before
the microswitch is actuated. Clockwise reduces the amount of travel
(shortening the trigger), counter-clockwise increases the trigger pre-
travel distance.
The trigger spring screw
B
adjusts the spring strength of the trigger
return. Clockwise increases the spring strength, counter-clockwise
reduces the spring strength.
The post-travel screw
C
adjusts the distance the trigger travels once
the microswitch has been actuated. Clockwise reduces the amount of
travel (shortening the trigger), counter-clockwise increases the trigger
post-travel distance.
B
A
–+
+–
–+
WARNING!
Always make sure the marker is OFF and de-gassed with a barrel blocking
device installed and that no paintballs are in the ETHA2 or loader before
adjusting the trigger.
Do not wind the screws in too far as this may prevent the ETHA2 from ring
or even damage the marker.
If the pre-travel screw is wound in too far this could cause the ETHA2 to
re unintentionally.
WARNING