Manual
FIG-1
09
ETHA2
QUICK START
STATUS INDICATOR
CB
FIG-1
The status indicator is visible on each side of the ETHA2 and is used to
indicate a number of dierent things.
Breech sensor status
After power up the ETHA2’s status indicator
C
will display the status
of the breech sensor (BS). The breech sensor (BS) is used to detect
paintballs in the breech of the marker.
The table below shows each LED colour and its relevant BS status.
LED COLOUR BREECH SENSOR (BS) STATUS
FLASHING YELLOW
BS enabled. NO paintball detected.
Marker WILL NOT re.
FLASHING LIGHT BLUE
BS enabled. Paintball detected.
Marker WILL re.
FLASHING PURPLE (SLOW)
BS disabled. Marker WILL re.
FLASHING PURPLE (FAST)
Blockage detected. BS disabled.
Marker WILL re.
RED
Replace battery.
Marker may or may not re.
Battery status
1
Tap the On/O button
B
.
2
The status indicator
C
will indicate the status of the battery for
2 seconds (see the table below for battery status colour information).
LED COLOUR BATTERY STATUS
GREEN Battery level is good.
YELLOW Battery level is low.
RED Replace the battery.
FLASHING RED Insufcient energy, replace battery immediately.
The status indicator also indicates the various marker parameter settings.
See pages 16-17.
WARNING!
When the battery indicator is being displayed the marker is still on and will re if
the trigger is pulled - depending on the BS status.
Do not dry re/shoot the marker without paintballs. Prolonged dry ring may
lead to damage/wear of the internal components of the marker.
WARNING