Manual

USING THE BREAK BEAM
SENSOR SYSTEM
The break beam sensor system, referred to elsewhere in
this manual as ‘BBSS’ is used to detect when a paintball is
ready to re from the Geo2. If no paintball is ready then
the BBSS will inhibit the Geo2 from ring. This prevents the
Geo2 from ‘chopping’ paintballs that are not fully loaded
into the marker.
To switch o the BBSS, press and hold the button for 0.5
seconds SEE FIGURE 3.3.
The BBSS indicator on the top right of the LCD will change
from (enabled) to (disabled).
To switch the BBSS back on, press and hold the button
for 0.5 second. The indicator will change back to .
When the BBSS is enabled, the indicator will change
depending upon whether the system has detected a ball
or not. When no ball has been detected the indicator
looks like this when a ball has been detected the icon
changes to look like this .
Additional features of the Geo2’s Break Beam Sensor
System are covered in full on page 24 of this user manual.
1
When the Geo2 is turned on, the Break Beam Sensor System is
automatically enabled.
FIG 3.3
16.
QUICk SET-UP