Manual

SETTING UP YOUR GEO2
Before you can begin to use your Geo2, you will need to
attach an air system and a paintball loader.
INSTALLING A PRESET AIR
SYSTEM
Every Geo2 comes complete with a new Eclipse Push
On/O Purge System (POPS) which provides a direct
connection for a preset air system. Before screwing an air
system into the POPS ensure that the Bonnet is disengaged
in its forward position SEE FIGURE 4.1. If the Bonnet is
engaged, depress the Latch Button and slide the Bonnet
forward.
Screw the preset air system into the POPS SEE FIGURE 4.2
so that the bottle screws in all the way and is tight. Pull the
Bonnet backwards allowing the POPS Pin to depress the
pin in the preset air system causing the Geo2 to become
pressurised (providing that there is sucient air in your
tank) SEE FIGURE 4.3. When the Bonnet has been pulled
back far enough it engages with the POPS Body.
1,2
You have now installed a preset air system onto your Geo2.
1
High, mid and low pressure output preset air systems can be used
with the Geo2, providing the Geo2 has the SL3 Inline Regulator
originally supplied with the marker.
2
The force needed to engage the Bonnet may vary depending on
the output pressure and internal design of the air system being
used.
WARNING: THE GEO2 CANNOT BE USED WITH CO2,
IT CAN ONLY BE POWERED BY COMPRESSED AIR OR
NITROGEN.
WARNING: ALWAYS RELIEVE ALL RESIDUAL GAS
PRESSURE FROM THE GEO2 BEFORE UNSCREWING THE
PRESET AIR SYSTEM.
FIG 4.3
FIG 4.2
FIG 4.1
WARNING: MAKE SURE THE MARKER IS TURNED OFF
AND THAT NO PAINTBALLS ARE IN THE MARKER OR
LOADER BEFORE INSTALLING AN AIR SYSTEM.
CONTENTS
ORIENTAT ION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
17.
USING yOUR GEO2
USING YOUR GEO2
QUICK GUIDE