Manual

ATTACHING A LOADER
Using a 5/32” hex key or your ngers, turn the sprocket
screw of the clamping feed neck counter clockwise SEE
FIGURE 5.1.
Release the clamping lever on the feed neck SEE FIGURE
5.2
and test to see if your loader can easily be pushed
into the top of the feed neck. If the loader cannot easily be
pushed into the feed neck, loosen the sprocket screw of
the clamping feed neck a little more by turning it counter
clockwise using a 5/32” hex key or your ngers SEE
FIGURE 5.1.
When you have managed to push your loader into the
clamping feed neck, close the clamp to secure it rmly
in place SEE FIGURE 5.3. If the loader is loose then you
will need to release the clamp, tighten the sprocket screw
slightly by turning it clockwise with a 5/32” hex key or
your ngers and close the clamp. Repeat this process as
necessary to secure your loader in place.
You have now attached a loader to your Geo2. Once you
have lled your loader and air tank you will then be ready
to begin using your Geo2.
WARNING: DO NOT OVER TIGHTEN THE CLAMPING
FEED NECK AS THIS MAY DAMAGE THE LOADER OR
FEED NECK ITSELF.
FIG 5.3
FIG 5.2
FIG 5.1
CONTENTS
ORIENTAT ION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
19.
USING yOUR GEO2
USING YOUR GEO2
QUICK GUIDE