Manual

RAMP SETUP
THE RAMP SETTINGS MENU
This menu is only available when ramping has been
selected with the FIRE MODE parameter and comprises a
list of parameters that control the way in which the Geo2
ramps, as shown below.
TYPE
THE RAMP TYPE PARAMETER
This parameter is used to select the ramping
style and has the following choices (see
opposite):
> STEP: Step ramping will cause the Geo2 to shoot in
semi-automatic until a number of trigger pulls, set by
SEMI SHOTS, have been made at a minimum pull rate, set
by KICK IN. At this point the rate of re will step up to the
maximum rate of re as set by BS ON ROF (or the maximum
loader speed if the ROF CAP parameter is set to o).
Ramping is maintained as long as the user continues to
pull the trigger at a required rate set by SUSTAIN.
> LINEAR: Linear ramping will cause the Geo2 to shoot in
semi-automatic until a number of trigger pulls, set by SEMI
SHOTS
, have been made at a minimum pull rate, set by KICK
IN
. At this point the rate of re will equal the rate of trigger
pulls increased by the percentage specied by RATE up to a
maximum rate of re as set by BS ON ROF, if the ROF CAP is
on. Ramping is maintained as long as the user continues to
pull the trigger at a required rate set by SUSTAIN.
> CANCEL: Editing is cancelled and no changes are made
to the parameter.
RATE
THE LINEAR RAMP RATE PARAMETER
The parameter is only available when LINEAR
ramping is selected and is used to set the
percentage increase in rate of re over rate
of trigger pulls.
For example, if the user is pulling the trigger
at a rate of 10 pulls per second and the
RATE
parameter is set to 50% then the rate of re
is 10 plus 50% extra which is 15 balls per
second.
This parameter can be set between 0 and 100% in 10%
increments.
36.
ADVANCED SET-UP