Manual

CLEANING THE PURGE
CONTROL VALVE PCV
This procedure is only required to x a degassing issue with
the Geo2, and is NOT part of regular Geo2 maintenance.
If the Geo2 does not degas/degasses very slowly or res
a shot when degassing, then the Purge Control Valve may
require maintenance.
Remove the Inline Regulator as covered on page 48. Turn
the Geo2 upside down to reveal the PCV Guide and PCV
SEE FIGURE 10.17. Using a 5/16” hex key unscrew the PCV
Guide, and remove the PCV Guide (A), PCV (B) and Spring
(C) from the Geo2 Body SEE FIGURES 10.18 & 10.19.
Inspect and clean the PCV and PCV Guide, paying
particular attention to the tip of the PCV. If the PCV or PCV
Guide is damaged replace with authentic Eclipse Parts.
These can be obtained from your nearest Eclipse Service
Centre (SEE FIGURE 10.20.
Place the PCV into the PCV Guide, FIGURE 10.21, followed
by the spring FIGURE 10.22. Then (keeping the PCV
Guide the correct way up) screw the PCV Guide back into
the Geo2 body FIGURE 10.23.
Re-attach the Inline regulator to the GEO2 as on page 49.
You have now cleaned the Purge Control Valve.
WARNING: IF YOU ARE AT ALL UNSURE AT PERFORMING
THE MAINTENANCE PROCEDURE PLEASE CONTACT YOUR
NEAREST ECLIPSE SERVICE CENTRE. SEE PAGE 69
FIG 10.17
FIG 10.19
FIG 10.21
FIG 10.22
FIG 10.18
FIG 10.20
FIG 10.23
THE PURGE CONTROL VALVE AND SPRING MUST BE
REPLACED CORRECTLY, FAILURE TO COMPLY WITH THIS
WARNING MAY CAUSE THE MARKER TO FIRE A SHOT
THAT COULD RESULT IN SERIOUS INJURY OR DEATH.
A
B
C
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS TO
MAKE THE MARKER EASIER AND SAFER TO WORK ON.
CONTENTS
ORIENTAT ION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
51.
mAINTENANCE
MAINTENANCE
QUICK GUIDE