Manual

THE GEO2 TRIGGER
ASSEMBLY
Remove the screws from the Geo2 frame that hold the
bearing carrier in place in the top of the frame SEE FIGURE
14.1
. Gently lift the bearing carrier and trigger assembly
free from the frame taking care not to damage the micro-
switch or the Opto sensors SEE FIGURE 14.2.
Using a 1/16” hex key, loosen the trigger pin retaining set
screw from the bottom of the trigger SEE FIGURE 14.3.
Use a small hex key to push the trigger pin out of the
bearing carrier from one side SEE FIGURE 14.4.
Clean the trigger and bearing carrier thoroughly and also
clean the space within the frame that the trigger sits into.
Carefully remove the trigger spring from the spring hole
in the top of the trigger and clean o any paint debris or
moisture from it SEE FIGURE 14.5.
FIG 14.2
FIG 14.3
FIG 14.1
FIG 14.4
FIG 14.5
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS TO
MAKE THE MARKER EASIER AND SAFER TO WORK ON.
CONTENTS
ORIENTAT ION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
61.
mAINTENANCE
MAINTENANCE
QUICK GUIDE