Manual

FIRE MODE
THE FIRING MODE PARAMETER
This parameter is used to select the ring
mode of the Geo2 and has the following
choices:
> SEMI: This is the default and in this ring
mode the Geo2 will re one shot for every
trigger pull.
> RAMP: In this ring mode, the rate of re is increased
above the rate at which the trigger is pulled once certain
criteria have been met. These criteria are set by the
parameters on the RAMP SETUP menu.
1
> CANCEL: Editing is cancelled and the parameter is
unchanged.
ROF CAP
THE RATE OF FIRE CAP PARAMETER
The ROF CAP parameter is used to specify
whether or not the Geo2 should have a
limited, or capped rate of re. When the ROF
CAP
is enabled, the maximum achievable
rate of re is set by the BS ON ROF parameter.
Choices for the ROF CAP parameter are:
> OFF: Rate of re only limited by the loader.
> ON: Rate of re limited to the BS ON ROF parameter value.
> CANCEL: Cancel editing and leave the parameter
unchanged.
BS ON ROF
THE MAXIMUM RATE OF FIRE
PARAMETER
The BS ON ROF parameter is used to set the
maximum achievable rate of re from the
Geo2. The value of this parameter can be
adjusted between 4.0 and 30.0 balls per
second in 0.1bps increments.
The
BS ON ROF parameter will only be
displayed if you have set the ROF CAP
parameter to ‘ON’.
BS OFF ROF
THE RATE OF FIRE WHEN BBSS IS OFF
PARAMETER
The BS OFF ROF parameter is used to control
how fast the Geo2 cycles when the Break
Beam Sensor System is disabled. This
parameter can be set between 4.0 and 15.0
balls per second and should always be set
to the slowest speed of the loading system
in use.
1
Some presets and re modes may only be available in certain
countries and on some models of the Geo2.
2
Always calibrate your Geo2 ROF CAP parameters to the local eld
BPS meter as readings may vary from meter to meter.
CONTENTS
ORIENTATION
QUICK SET-UP
USING YOUR GEO2
ADVANCED SET-UP
MENU TREE
MAINTENANCE
FAULT FINDING
SERVICE CENTRES
PARTS LIST
SPARES & ACCESSORIES
E-PORTAL
INDEX
35.
ADVANCED SET-UP
ADVANCED SET-UP
QUICK GUIDE