Manual
WARNING: DEGAS YOUR MARKER, DISCHARGING ANY
STORED GAS IN A SAFE DIRECTION, AND REMOVE THE
BARREL, LOADER, AIR SYSTEM AND ANY PAINTBALLS
TO MAKE THE MARKER EASIER AND SAFER TO WORK
ON.
THE GEO2 SOLENOID
ASSEMBLY
With the frame separated from the Geo2 body and the
Solenoid Assembly and BBSS Assembly unplugged from
the Circuit Board (see page 55) use a 5/64” hex key to
undo and remove the two screws that hold the Solenoid
Assembly onto the Geo2 body SEE FIGURE13.1.
With the Solenoid Assembly completely removed from
the Geo2 body the bottom of the Geo2 body should now
resemble FIGURE 13.2 Ensure that the air transfer holes
in the bottom of the body are free from contamination
from any dirt, debris, paint or moisture and clear away
any excess grease if it appears to be blocking any of the
transfer holes.
Check the underside of the Solenoid Assembly to ensure
that it is also free from damage or debris
SEE FIGURE 13.3
and remove the rubber gasket to clean the lter section as
shown in FIGURE 13.4 Replace the rubber gasket ensuring
that it lies at in its designated groove in the manifold
body SEE FIGURE 13.5.
If you are replacing a defective Pilot Assembly, unscrew
it from the manifold now and replace it with a new Pilot
Assembly unit
SEE FIGURE 13.6.
FIG 13.2
FIG 13.3
FIG 13.4
FIG 13.1
FIG 13.6
FIG 13.5
58.
MAINTENANCE