User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-108-
3. In the AP-1, go to “System-> Operation Mode” and set it to use “WDS Access Point” mode. Then, click
“Save & Apply”.
4. In the AP-1, go to “Wireless-> Wireless Network” to configure channel and click “Edit” for security setting.
(1) Channel HT Mode: set to “40MHz” for wider bandwidth
(2) Channel/Frequency: uncheck “Auto” and set to a fixed channel