User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-30-
5.1.2 Client Bridge (CB)
This section allows you to configure the Client Bridge mode. In this mode, the device enables the wired client to
be connected to the central site through wireless interface.
Go to the “System Operation Mode” page to configure the device as “Client Bridge” and then go to
“Wireless
Wireless Network” to configure the related wireless settings.
Figure 5-3 Operation Mode – Client Bridge
For the configuration example, please refer to the section “
Appendix C: FAQ, Q1”.