User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-34-
Step 2. Go to the “System IP Settings” page to configure LAN IP of central site and remote site. The LAN IP
must be different at both sites. In this example, the master AP at the central site is configured to
192.168.1.252 and the slave AP at remote site is configured to 192.168.1.253.
Step 3. Go to the “Wireless Wireless Network” page to configure the wireless parameters of the WDS link.