User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-44-
5.1.7 Repeater
This section allows you to configure the Repeater mode to extend the root AP’s signal coverage.
Go to the “System Operation Mode” page to configure the device as “Repeater” and then go to “Wireless
Wireless Network” to configure the related wireless settings.
Figure 5-8 Operation Mode – Repeater
Configuration Example
The following procedure will guide you to how to establish repeater connection.
Step 1. Go to “Operation Mode” page to configure the device as “Repeater”.