User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-55-
5.3 System
5.3.1 IP Settings
Click “System IP Settings” to configure the LAN IP address.
Figure 5-20 LAN IP Settings
The page includes the following settings:
Object Description
• IP Network Setting
Select Obtain an IP address automatically (DHCP) to receive the IP
from DHCP server.
Select Specify an IP address to configure the AP to use static IP.
• IP Address
The LAN IP of the AP.
The default is 192.168.1.253. You can change it according to your needs.
• IP Subnet Mask
The LAN subnet mask of the AP.
• Default Gateway
Enter the Gateway IP address of the AP.
• Primary DNS
Enter the primary DNS server of the AP.
• Secondary DNS
Enter the secondary DNS server of the AP.
• Use Link-Local Address
Click to enable a link-local address for the AP.