User's Manual

User Manual of WAP-200N/WBS-200N
-56-
• IPv6 IP Address
Enter the IPv6 LAN IP of the AP.
• IPv6 Subnet Prefix Length
Enter the secondary DNS server of the AP.
• IPv6 Default Gateway
Enter the IPv6 Gateway IP address of the AP.
• IPv6 Primary DNS
Enter the IPv6 primary DNS server of the AP.
• IPv6 Secondary DNS
Enter the IPv6 secondary DNS server of the AP.
• Accept
Click Accept to apply the new settings.
• Cancel
Click Cancel to cancel the unsaved changes and revert to the previous
settings.
5.3.2 Spanning Tree Settings (STP)
The Spanning Tree Settings (STP) protocol allows network to provide a redundant link in the event of a link
failure. It is advised to turn on this option for multi-point bridge network to avoid network loop.
Click “System  Spanning Tree Settings” to enable/disable Spanning Tree Settings.
Figure 5-21 Spanning Tree Settings
The page includes the following settings:
Object Description
• Spanning Tree Status
Click ON to enable or click OFF to disable the option.
• Bridge Hello Time
Specify Bridge Hello Time, in seconds. This value determines how often
the AP sends hello packets to communicate information about the
topology throughout the entire Bridged Local Area Network.
• Bridge Max Age
Specify Bridge Max Age, in seconds. If another bridge in the spanning
tree does not send a hello packet for a long period of time, it is assumed
to be dead.
• Bridge Forward Delay
Specify Bridge Forward Delay, in seconds. Forwarding delay time is the
time spent in each of the Listening and Learning states before the