User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-57-
Forwarding state is entered. This delay is provided so that when a new
bridge comes onto a busy network, it looks at some traffic before
participating.
• Priority
Specify the Priority number. Smaller numbers have greater priority.
• Accept
Click Accept to apply the setting.
• Cancel
Click Cancel to cancel the setting.
5.4 Router (WISP Mode Only)
5.4.1 DHCP Server Settings
Go to the “Operation Mode” page to configure the device as “Client Router” and then go to “Router LAN
Settings” to configure the device’s LAN IP settings in client router mode.
On this page, enable the DHCP server to assign IP address to local wired/wireless clients after the device is
connected to the remote AP supplied by wireless ISP.
Figure 5-22 DHCP Server Settings
The page includes the following settings:
Object Description
• IP Address
The LAN IP of the AP.
• IP Subnet Mask
The LAN subnet mask of the AP.
• Use Router As DHCP
Server
Select it to enable DHCP server. In here the device is acting as a router.
• Starting IP Address
Specify the starting IP address for the DHCP range.