User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-59-
assigned a different address.
• PPPoE: Point-to-Point Protocol over Ethernet (PPPoE) is used mainly
by ISPs that provide DSL modems to connect to the Internet.
• PPTP: The point-to-point tunneling protocol (PPTP) is used in
association with virtual private networks (VPNs).
Options: This section will not be the same depending on the Internet Connection Type.
Refer to settings of each corresponding section from 5.4.2.1 to 5.4.2.4
Domain Name Server (DNS) Address
• Get Automatically From ISP
Select it to obtain the DNS automatically from the DHCP server.
• Use These DNS Servers
Select it to set up the Primary DNS and Secondary DNS servers
manually.
• Primary DNS
Enter the primary DNS server address.
• Secondary DNS
Enter the secondary DNS server address.
WAN Ping
• Discard Ping on WAN
Check it to enable pings on the WAN interface or disable to block pings on
the WAN interface.
• Accept
Click Accept to apply the setting.
• Cancel
Click Cancel to cancel the setting.
5.4.2.1. DHCP
Select DHCP and the device will automatically obtain IP addresses, subnet masks and gateway addresses from
the ISP.