User's Manual

User Manual of WAP-200N/WBS-200N
-64-
The page includes the following specific settings in PPTP type:
Object Description
• MTU
The maximum transmission unit (MTU) specifies the largest packet size
permitted for an internet transmission. The factory default MTU size for
PPTP is 1400. The MTU size can be set between 1200 and 1400.
• IP Address
Enter the device’s WAN IP address provided by ISP.
• Subnet Mask
Enter the device’s WAN IP subnet mask provided by ISP.
• Default Gateway
Enter the device’s WAN Gateway IP provided by ISP.
• PPTP Server
Enter the IP address of the PPTP server.
• Username
Enter the username provided by ISP.
• Password
Enter the password provided by ISP.
• Connect on Demand
Select it to specify the maximum idle time. Internet connection will
disconnect when it reaches the maximum idle time, but it will
automatically connect when user tries to access the network.
• Keep Alive
Select whether to keep the Internet connection always on, or enter a
redial period once the internet loses connection.
• Accept
Click Accept to apply the setting.
• Cancel
Click Cancel to cancel the setting.
5.4.3 VPN Pass Through
VPN Pass-through allows a secure virtual private network (VPN) connection between two sites. Enabling the
options on this page opens a VPN port and enables connections to pass through the AP without interruption.
Go to the “Operation Mode” page to configure the device as “Client Router” and then go to “Router  VPN
Pass Through” to enable VPN pass through you required in client router mode.
Figure 5-28 VPN Pass Through