User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-65-
The page includes the following settings:
Object Description
• PPTP Pass Through
Check this option to enable PPTP pass-through mode.
• L2TP Pass Through
Check this option to enable L2TP pass-through mode.
• IPSec Pass Through
Check this option to enable IPSec pass-through mode.
• Accept
Click Accept to apply the setting.
• Cancel
Click Cancel to cancel the setting.
5.4.4 Port Forwarding
Go to “Operation Mode” page to configure the device as “Client Router” and then go to “Router Port
Forwarding” to enable VPN pass through you required in client router mode.
Figure 5-29 Port Forwarding
The page includes the following settings:
Object Description
• #
Displays the sequence number of the forwarded port.
• Name
Displays the name of the forwarded port.
• Protocol
Displays the protocol to use for mapping from the following: TCP, UDP or
Both.
• Start Port
Displays the LAN port number that WAN client packets will be forward to.
• End Port
Displays the port number that the WAN client packets are received.
• Server IP Address
Displays the IP address of the server for the forwarded port.
• Enable
Click to enable or disable the forwarded port profile.
• Modify
Click to modify the forwarded port profile.
• Delete
Click to delete the forwarded port profile.
• Add Entry
Click Add Entry to add the new forwarding rule.
• Accept
Click Accept to apply the setting.