User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-70-
Figure 5-34 Wireless Network – CB/WDS STA/CR/Repeater Mode
The page includes the following settings:
Object Description
• Wireless Mode
Wireless mode supports 802.11b/g/n mixed modes.
• SSID
Specify the SSID if known. This field is completed automatically if you
select an Access Point in the Site Survey.
• Site Survey
Scans nearby locations for Access Points. You can select a discovered
Access Point to establish a connection.
• Prefer BSSID
Enter the MAC address if known. If you select an Access Point in the Site
Survey, this field is completed automatically.
• Wireless Security
Refer to section
5.5.3 Security Setting.
• Accept
Click Accept to apply the setting.
• Cancel
Click Cancel to cancel the unsaved changes and revert to the previous
settings.
5.5.2 WDS Link Settings
Go to the “Operation Mode” page to configure the device as “WDS Bridge” and then go to “Wireless WDS
Link Settings” to configure the WDS link settings including PtP (Point to Point) or PtMP (Point to Multiple Points)
applications.