User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-71-
Figure 5-35 WDS Link Settings – WDS Bridge Mode
The page includes the following settings:
Object Description
• Security
Select the type of WDS security: None, WEP, or AES.
• WEP Key
Enter the WEP key if select security as WEP.
• AES Passphrase
Enter the AES passphrase if select security as AES
• MAC Address
Enter the wireless MAC address of the AP to which you want to extend
wireless connectivity.
• Mode
Select Disable or Enable to disable or enable WDS.
• Accept
Click Accept to save the settings.
• Cancel
Click Cancel to cancel the unsaved changes and revert to the previous
settings.
NOTE:
1. The WDS link setting is only available in WDS Bridge mode and is communicating through
wireless MAC address to each other by using non-standard protocol which may not be
compatible with other brands/models of device. Using the same model for full compatibility is
required.
2. The security setting in each site of WDS link must be the same.
3. The wireless channel must be fixed and must be the same in each site of WDS link.