User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-74-
Figure 5-39 Security Settings – WEP
The security mode includes the following settings:
Object Description
• Security Mode
Select WEP from the drop-down list to configure the wireless network
using WEP encryption method.
• Auth Type
Select Open System or Shared.
• Input Type
Select an input type of Hex or ASCII.
• Key Length
Level of WEP encryption is applied to all WEP keys.
Select a 64-/128-/152-bit password length.
40/64-bit: enter 10 hexadecimal digits (any combination of 0-9, a-f,
A-F and null key is not permitted) or 5 ASCII characters.
104/128-bit: enter 26 hexadecimal digits (any combination of 0-9,
a-f, A-F and null key is not permitted) or 13 ASCII characters.
128/152-bit: enter 32 hexadecimal digits (any combination of 0-9,
a-f, A-F and null key is not permitted) or 16 ASCII characters.
• Default Key
Select 1 – 4 to specify which of the four WEP keys the device uses as its
default.
• Key1 – Key4
Specify a password for the security key index. For security, each typed
character is masked by a dot.
• Save
Click Save to save the settings.
• Cancel
Click Cancel to cancel the unsaved changes and revert to the previous
settings.