User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-82-
5.5.4 Wireless MAC Filter
Wireless MAC Filters are used to allow or deny network access to wireless clients according to their MAC
addresses. You can manually add a MAC address to restrict the permission to access the device or refer to
section 5.2.3 to kick the associated client from the wireless client list.
Click “Wireless Wireless MAC Filter” to configure the wireless access control settings.
Figure 5-46 Wireless MAC Filter
The page includes the following settings:
Object Description
• ACL Mode
Determines whether network access is granted or denied to clients whose
MAC addresses appear in the MAC Address table on this page. The
option includes Disable, Deny MAC in the list, or Allow MAC in the list.
• Add
Enter the wireless MAC address of the client in front of the Add button
and then click Add to add the new entry to the MAC filtering list.
• #
Displays the sequence number of the entries.
• MAC Address
Displays the MAC Address that will be denied/allowed to access this
device.
• Delete
Click Delete to remove the entry from the list.
• Accept
Click Accept to apply the setting.