User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-83-
5.5.5 Wireless Advanced Settings
Click “Wireless Wireless Advanced Settings” to configure the wireless advanced settings.
This section allows you to configure the wireless related settings to optimize the wireless network.
Figure 5-47 Wireless Advanced Settings
The page includes the following settings:
Object Description
• Data Rate
Select a data rate from the drop-down list. The data rate affects
throughput. If you select a low data rate
value, for example, the
throughput is reduced but the transmission distance increases. The
default is “Auto”.
• Transmit Power
The transmission power of the device (value: auto).
To meet the regional regulation, this option is not allowed to be configured
through the user interface.
• RTS/CTS Threshold
When the length of a data packet exceeds this value, the device will send
an RTS frame to the destination wireless node, and the latter will reply
with a CTS frame, and thus they are ready to communicate. The default
value is 2346. A small number causes RTS/CTS packets to be sent more