User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-87-
• Community Name
(Read/Write)
Enter the password for accessing the SNMP community for read and
write access.
• Trap Destination Address
Enter the IP address where SNMP traps are to be sent.
• Trap Destination
Community Name
Enter the password of the SNMP trap community.
• SNMPv3
Enable or Disable the SNMPv3 feature.
• User Name
Specify the username for SNMPv3.
• Auth Protocol
Select the authentication protocol type: MD5 or SHA.
• Auth Key (8-32 Characters)
Specify the authentication key for authentication.
• Priv Protocol
Select the privacy protocol type: DES.
• Priv Key (8-32 Characters)
Specify the privacy key for privacy.
• Engine ID
Specify the engine ID for SNMPv3.
• Save/Apply
Click Save/Apply to apply all changes.
• Cancel
Click Cancel to cancel the settings.
5.6.4 Backup/Restore Settings
Click “Management Backup/Restore Settings” and the following page will be displayed.
Figure 5-51 Backup/Restore Settings
The page includes the following settings:
Object Description
• Save A Copy of Current
Settings
Click Backup to save the current configured settings.
• Restore Saved Settings
from A File
To restore settings that have been previously backed up, click Choose
File to select the file, and click Restore.
• Revert to Factory Default
Settings
Click Factory Default to restore the device to its factory default settings.