User's Manual
Table Of Contents
- Chapter 1. Product Introduction
- Chapter 2. Hardware Installation
- Chapter 3. Connecting to the AP
- Chapter 4. Quick Installation Guide
- Chapter 5. Configuring the AP
- Appendix A: Troubleshooting
- Appendix B: Use Planet Smart Discovery to find AP
- Appendix C: FAQ
User Manual of WAP-200N/WBS-200N
-92-
5.6.9 CLI Settings
The command line interface (CLI) allows user to access the device through a command console, modem or
Telnet connection for configuration.
Click “Management CLI Settings” to enable/disable CLI (Command Line Interface).
Figure 5-56 CLI Settings
The page includes the following settings:
Object Description
• CLI
Select ON/OFF to enable or disable the ability to modify the device via a
command line interface (CLI).
• Save/Apply
Click Save/Apply to apply all changes.
• Cancel
Click Cancel to cancel the settings.
5.6.10 Log
Click “Management Log” to enable/disable system log.
Figure 5-57 Log