User's Manual

and then you can configure the
Guest Network Settings
and then you can configure the
RSSI Threshold
The RSSI Threshold
is used when a weakening wireless link between AP and client is detected below the
specific RSSI, the AP will encourage client to access the nearby AP with stronger signal, thus ensure stable
wireless connectivity.
Figure
The page includes the following settings
Object
Description
• Status
Click
• RSSI (Received Signal
Strength Index)
Specifies the
Range:
RSSI is an indication of
Therefore,
4.5.7 Management VLAN
Go to the “Network
Wireless”
page to configure the device as
and then you can configure the
Management VLAN
If your network includes VLANs and if tagged packets need to pass through the Access Point,
management VLAN settings and
enter the
Figure
The page includes the following settings
Object
Description
User
Manual of
-58-
Guest Network Settings
in the bottom of the page.
RSSI Threshold
in the bottom of the page.
is used when a weakening wireless link between AP and client is detected below the
specific RSSI, the AP will encourage client to access the nearby AP with stronger signal, thus ensure stable
Figure
4-42 Wireless - RSSI Threshold
The page includes the following settings
:
Description
Click
Enable to enable the RSSI Threshold.
Specifies the
RSSI value
to limit the client access.
Range:
-60dBm ~ -100dBm
RSSI is an indication of
the power level being received by the antenna.
Therefore,
the higher the RSSI number, the stronger the signal.
page to configure the device as
“Access Point” or “
WDS
Management VLAN
Settings in the bottom of the
page.
If your network includes VLANs and if tagged packets need to pass through the Access Point,
enter the
VLAN ID. Otherwise, keep it disabled.
Figure
4-43 Wireless – Management VLAN
The page includes the following settings
:
Description
Manual of
WBS-502AC
is used when a weakening wireless link between AP and client is detected below the
specific RSSI, the AP will encourage client to access the nearby AP with stronger signal, thus ensure stable
to limit the client access.
the power level being received by the antenna.
the higher the RSSI number, the stronger the signal.
WDS
Access Point” mode
page.
If your network includes VLANs and if tagged packets need to pass through the Access Point,
enable the