- Planet WAN Router User's Manual

31
sdlc role – establish role of the interface
sdlc-largest-frame- Set the largest I-frame size that can be sent or received by the
designated SDLC station
sdlc simultaneous [full-datemode | half-datamode] - full-datemode is enable the primary
station to send data to and receive data from the polled secondary station. half-datamode is
Prohibit the primary stations from sending data to the polled secondary station.
sdlc t1 - Control the amount of time the Cisco IOS software waits for a reply
sdlc vmac – configure a MAC for the serial interface.
sdlc dlsw – enable DLSw on an SDLC interface
sdlc xid - Specify the XID value to be associated with the SDLC station
sdlc poll-limit-value – configure the number of times router can poll a secondary station time
sdlc poll-pause-timer – configure the time that router pause between sending each poll frame
to secondary station
sdlc poll-wait-timeout - specify the interval the router will wait for polls from a primary node
before timing out that connection.
sdlc rnr-limit – configure the time that router allows its adjacent linkstation to remain in a busy
(RNR) state before declaring it inoperative
sdlc slow-poll – enable the slow-poll capability of the router as a primary SDLC station
sdlc t2 – configure the pool time
Token-
ring
500
IBM host
FEP
ROUTE AROUTE B
400.1020.1000
PU type 2.0
sdlc address
01
Figure 6-1 sna configuration example
Configuration for Router A: