User's Manual

Chapter 2 Installation
Please follow these steps to install the converter:
。 Turn off the power of the device/station in a network to which the FT-807 will be
attached.
。 Ensure that there is no activity in the network.
。 Attach POF fiber cable with SMI type connector from the FT-807 to the fiber
network also using POF.
。 Attach a Cat. 5 UTP cable from the 10/100Base-TX network to the RJ-45 port
on the FT-807.
。 Connect the 5VDC power adapter to the FT-807 and verify that the Power LED
lights up.
。 Turn on the power of the device/station, the TP and POF LED should light when
all cables are attached.
Note:
1. RJ-45/STP, UTP Cat 5, straight/crossover cable is accepted.
2. Please note the FT-807 supports LFP function, both ends should well
connected. Otherwise, both TP and fiber port will remains off if any of the port is
not connected
3. Consult for your network administrator for more information about POF network
equipments. Usually, another FT-807 is required for pair installation and
transmission.
Warning: As an optical equipment, to reduce the risk of injury to the eyes, do not
look directly into the laser light on the POF interface and do not point the
laser light into anyone's eyes in short distance.