User's Manual

– 1 – – 2 –
– 3 – – 4 –
1. Overview
Thank you for purchasing PLANET 75-watt AC power supply for
GPL-8000.
Power Supply Unit Input Range
GPL-PWR75-AC 100 to 240V AC
Open the box of the Redundant Power Supply unit and carefully
unpack it. The box should contain the following items:
 The AC Power Supply unit x 1
 User’s Manual x 1
 Power Cord x 1
If any item is found missing or damaged, please contact your local
reseller for replacement.
2. Introduction
Before installation, please be sure to read this user’s manual
carefully to successfully complete the correct installation of the
GPL-PWR75-AC 75-watt AC Power Supply Unit. This manual shows
how to quickly install the power in the GPL-8000.
The following gure shows the front panel of the GPL-PWR75-AC
GPON OLT.
Figure 2-1 GPL-PWR75-AC Front View
3. Installing Redundant Power Supply
Unit
Note
The GPL-PWR75-AC is hot-swappable, so there is no
need to power off the GPON OLT before removing it
from the GPON OLT.
Follow these steps to install the redundant power in the GPON OLT:
1. Place the GPON OLT on a at surface. Use a screwdriver to
unscrew screws on both sides of the blank plate to remove the
blank plate. Do not discard the blank plate as it can be used
again when removing the power supply unit from the GPON OLT.
2
1
1
Figure 3-1 Removing the Blank Plate
2. Install the redundant power by sliding it into the compartment.
1
2
2
Figure 3-2 Sliding the Power Supply Unit into the Compartment
3. Next, tighten the thumbscrews on both sides.
Figure 3-3 Tightening the Thumbscrews