User's Manual

Table Of Contents
140
Users Manual of GPL-8000
7.9.2.2 RMON History Information Configuration
If you click Remote Monitor -> RMON Config -> RMON history -> New, the RMON history page appears.
Figure 7: Configuring the RMON history information
You need to set a physical port to be the reception terminal of the monitor data.
The index is used to identify a specific interface; if the index is same to that of the previous application
interface, it will replace that of the previous application interface.
The sampling number means the items that need be reserved, whose default value is 50.
The sampling interval means the time between two data collection, whose default value is 1800s.
At present, the monitor statistic information can be obtained through the command line “show rmon history”,
but the Web does not support this function.
7.9.2.3 RMON Alarm Information Configuration
If you click Remote Monitor -> RMON Config -> RMON Alarm -> New, the RMON Alarm page appears.
Figure 8: Configuring the RMON alarm information
The index is used to identify specific alarm information; if the index is same to the previously applied index, it
will replace the previous one.
The MIB node corresponds to OID.
If the alarm type is absolute, the value of the MIB object will be directly minitored; if the alarm type is delta, the
change of the value of the MIB object in two sampling will be monitored.
When the monitored MIB object reaches or exceeds the rising threshold, the event corresponding to the index
of the rising event will be triggered.
When the monitored MIB object reaches or exceeds the falling threshold, the event corresponding to the