Quick Guide
Step 3: Please align the screw holes on the HDD with those on the HDVR case and secure
them with the given screws.
Step 4: After the HDD is secured, it should look like the one in the pictures (front and
back) below:
Contents
Quick Installation Guide x 1 Power Adapter x 1 Screw Kit x 1 RS485 Connector x 1
SATA Cable x 1 SATA Power Cable x 1
*
SATA cable, SATA power cable and RS485 connector are included in the HDVR.
Hard Disk Installation
Caution
Before installing the HDD, please make sure there is no pre-conīægured
partition in this HDD. If yes, please delete all the partitions before the
installation.
Step 1: Remove the upper case.
Step 2: Plug the HDD power cable and SATA cable into the slots of the PCBA board and the
HDD, respectively, making sure the connections are well done.
Hardware Connection
HDVR-1635
HDVR- 835
HDVR-435
Name Description
CH1-CH16 Composite video broadcast signal (CVBS) input interface
AUDIO IN 1-4 The input interface of the audio signal
AOUT/VOUT The output interface of the audio/video signal
LAN The network interface of RJ45
HDMI The output interface of the HDMI video signal
VGA The output interface of the VGA video signal
Power 12V DC, 2A
485+/485- The interfaces of the alarm input, the alarm output and RS485
- 1 - - 2 - - 3 - - 4 -